User Tools

Site Tools


rancilio_silvia

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Next revision
Previous revision
rancilio_silvia [2023/07/30 21:14] – created davidrancilio_silvia [2023/07/30 21:17] (current) david
Line 13: Line 13:
   - Wipe the steam wand off as soon as it is out of the milk.   - Wipe the steam wand off as soon as it is out of the milk.
   - Switch off the steam switch.   - Switch off the steam switch.
-  - The machine needs to be cooled down before it can make espresso or it will scorch the coffee. It can be cooled by opening the steam  +  - The machine needs to be cooled down before it can make espresso or it will scorch the coffee. It can be cooled by opening the steam knob and pumping cold water into the boiler from the tank. Use the Hot Water/pump switch to push cold water into the boiler. Don't pump water into the boiler if it has no place to go. Get the machine below 105 C and the PID will heat it back up to 105 c.
-  - knob and pumping cold water into the boiler from the tank. Use the Hot Water/pump switch to push cold water into the boiler. Don't pump water into the boiler if it has no place to go. Get the machine below 105 C and the PID will heat it back up to 105 c.+
   - Weigh out 17.5 g of beans.   - Weigh out 17.5 g of beans.
   - Grind on approx #4 on the grinder   - Grind on approx #4 on the grinder
Line 26: Line 25:
   - Shot should take between 28-30 seconds and be 40 grams. If it is fast grind finer. Slow grind courser.   - Shot should take between 28-30 seconds and be 40 grams. If it is fast grind finer. Slow grind courser.
   - Pour the milk on top of the espresso shot   - Pour the milk on top of the espresso shot
-Press the play button on + 
 ==== Espresso ==== ==== Espresso ====
 +
 +  - Turn on machine with power switch
 +  - Wait for the PID to heat the boiler to 105 C. Current temp is displayed on the PID
 +  - Weigh out 17.5 g of beans.
 +  - Grind on approx #4 on the grinder
 +  - Clean the portafilter. Fill with the grounds.
 +  - Put on the dosing ring. Use the wisk to remove any clumps.
 +  - Remove the dosing ring. Tamp with at least 30 LBs. Its is not possible to over tamp.
 +  - Put on the puck screen
 +  - Put the porafilter into the machine. Make sure the shot switch is on.
 +  - Put a cup on the scale under the portafilter.
 +  - Press the play button on the PID. It will run the shot. You can press the play button again to stop the shot early.
 +  - Shot should take between 28-30 seconds and be 40 grams. If it is fast grind finer. Slow grind courser.
 +  - Stir espresso with a spoon
rancilio_silvia.1690751673.txt.gz · Last modified: 2023/07/30 21:14 by david